KitchenAid 27" Installation Instructions Manual page 8

3. It is recommended that if a wood or porous custom drawer
front is installed, a high quality spar polyurethane finish be
applied to the inner wood surface.
4. For the lens, drill a ⁵⁄₁₆" (7.9 mm) diameter hole through the
appearance side of the custom drawer front. This hole will
allow the indicator "ON" light to be visible through the custom
drawer front. To secure the lens, use an adhesive specified for
plastic to wood application.
5. Install custom handle (not supplied) through custom drawer
front.
8
6. The custom drawer front is fastened to the stainless steel
drawer by driving 6 screws through clearance holes in the
drawer front into the wooden or other custom made panel.
A
B
E
www.goedekers.com
D
C
D
A. Optional handle
B. Custom door panel
C. Warming drawer front
¹⁄₂
D. 6 - #8-18 x " screws
E. Lens