ESAB Warrior 500i CC/CV Instruction Manual page 11

US
Connection instruction
The power source is connected to 460V from the factory. If a different mains voltage
is required, the cable on the printed circuit board must be moved and placed on the
correct pin. See picture above. This operation must be carried out by personnel
having appropriate electrical knowledge.
Installation of mains cable
A mains cable needs to be installed. It is then important that the earth connection to
the bottom plate must be made in a correct way. See the picture above for the order
in which the washers, nuts and screws are placed.
- 11 -
bu22a © ESAB AB 2013