Table of Contents
Advertisement
ENGLISH
Use
Warning! Let the tool work at its own pace. Do not overload.
easily done before. The battery may become warm while
charging; this is normal and does not indicate a problem.
Warning! Do not charge the battery at ambient temperatures
below 10 °C or above 40 °C. Recommended charging
temperature: approx. 24 °C.
Note: The charger will not charge a battery if the cell
temperature is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell
temperature warms up or cools down.
To charge the battery (4), insert it into the charger (19).
force. Be sure that the battery is fully seated in the
charger.
Plug in the charger and switch on at the mains.
(slowly).
The charge is complete when the charging indicator (20) lights
green continuously. The charger and the battery can be left
occasionally tops up the battery charge. The charging
indicator (20) will be lit as long as the battery is connected to
the plugged-in charger.
Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
pack fresh and fully charged.
Charger diagnostics
If the charger detects a weak or damaged battery, the
follows:
Re-insert the battery (4).
rate, use a different battery to determine if the charging
process works properly.
8
(Original instructions)
If the replaced battery charges correctly, the original
battery is defective and should be returned to a service
centre for recycling.
If the new battery gives the same indication as the original
battery, take the charger to be tested at an authorised
services centre.
Note: It may take as long as 60 minutes to determine that
the battery is defective. If the battery is too hot or too
cold, the LED will alternately blink red, fast and slow, one
Setting the tool to trimming or edging mode
edging mode to trim overhanging grass along lawn edges and
For trimming, the trimmer head should be in the position
Disconnect the tool from the supply.
Loosen the adjustment collar (6) by turning it clockwise.
Whilst holding the handle (2), rotate the head (8)
clockwise.
Tighten the collar (6) by turning it anti-clockwise.
Slide the edge guide (9) into the motor housing.
Note: Note: The head will only rotate in one direction.
For edging, the trimmer head should be in the position shown
Disconnect the tool from the supply.
Loosen the adjustment collar (6) by turning it clockwise.
Whilst holding the handle (2), rotate the head (8)
anti-clockwise.
Tighten the collar (6) by turning it anti-clockwise.
Slide the edge guide out of the motor housing. Ensure that
the edging guide (9) is fully extended, an audible click will
be heard.
Note: The head will only rotate in one direction.
Switching on and off
To switch the tool on, press in and hold the lock off button
(3) then squeeze the trigger lever (1). Once the tool is
running you may release the lock off button (3).
To switch the tool off, release the trigger lever.
Warning! Never attempt to lock the trigger lever in the on
position.
Hide quick links:
Advertisement
Table of Contents
