Peavey DM 115 Operating Manual page 16

Overall Dimensions ( H x W x D )
28.3"H x 16.75"W x 15.00"D
719 mm x 426 mm x 381 mm
Weight: 42 lbs. (19.1 kg)
ELECTRONICS AND AMPLIFIER SPECIFICATIONS:
Internal power amplifiers (@120 VAC line):
Total of 660 watts peak dynamic power
Woofer - 410 watts peak dynamic power
Continuous Power: 125 watts @ less than 1% distortion
Tweeter - 250 watts peak dynamic power
Continuous Power: 80 watts @ less than 1% distortion.
Electronic Input Impedance (Nominal):
Line: 4.5 k ohms balanced (XLR or 1/4")
Mic: 4.5 k ohms balanced (XLR) No phantom power available.
Input Sensitivity for Full Output (Level full CW): 0.39 V RMS
(Switch in LINE position)
Input Overload Point (Switch in LINE position): +17 dBV
Infrasonic filter protection: 36 dB/octave roll-off
Nominal Amplifier Frequency Response: +1, -3 dB from 20 Hz to 20 kHz
Hum and Noise: Greater than 90 dB below rated power
THD and IM: Typically less than 0.7 %
Power requirements of Peavey DM™115 System:
Nominal 170 Watts, 120 VAC 60 Hz
Fuse Type
For 120 VAC USE: International fuse classification T4AH 250V. In the USA, types GDC, GMC, 215, 218, and
477 cartridge-style 5 x 20 mm size fuses with a 4 amp 250V rating can be used.
For 220-240VAC USE: International fuse classification T2AHL 250V . This is a cartridge style 5 x 20 mm size
time-delay fuse with a 2 amp 250V rating.