Cisco Aironet 340 Series Quick Start Manual page 5

10Base2
connector
Attaching 10Base2 Cabling
1
Attach the 10Base2 (Thinnet) cabling to
a BNC T-connector.
2
Attach the T-connector to the 10Base2
connector on the bridge.
3
If the unit is at the end of the Ethernet
cable, install a 50-ohm terminator on
the open end of the T-connector.
Caution
Removing a terminator
to install extra cable or breaking an
existing cable to install a
T-connector will cause a disruption
in Ethernet traffic. Consult your
LAN administrator before you
change any Ethernet cable
connections.
10 B as e
1 0 B a s e
2
1 0 B a s e
2
1 0 B a s e
5
10Base5
connector
2
10 B as e
5
1 0B as e
T
1 0 B a s e
10BaseT
connector
Attaching 10Base5 Cabling
1
Attach the transceiver connector to the
10Base5 (Thicknet) port.
2
Slide the locking mechanism into place.
3
Attach the other end of the transceiver
drop cabling to an external transceiver.
Attaching 10BaseT Cabling
1
Plug the RJ-45 connector into the
10BaseT (twisted pair) port.
2
Connect the other end of the twisted
pair cabling to the 10BaseT Ethernet
LAN connection.
5
1 0 B a s e
T
3