Table of Contents
Advertisement
^ Feed the connection cable down
through the cut-out.
^ Place the appliance into the worktop
cut-out, starting with the front of the
appliance.
^ Using both hands, press down
evenly on the sides of the appliance
until it clicks into position. When
doing this, make sure that the seal
sits flush with the worktop on all
sides. This is important to ensure an
effective seal all round. Do not use
sealant.
When installing several appliances, a
cover must be inserted into the spacer
bar.
^ Slide the installed appliance to one
side until you can see the holes of the
spacer bar.
^ Insert the cover d into the holes of
the spacer bar b.
Installing the appliance(s)
^ Place the appliance into the worktop
cut-out, starting with the front of the
appliance.
^ Connect the appliance to the mains
electricity (see "Electrical
connection").
^ Check that the appliance works.
Once installed, the appliance can be
lifted out using a special tool.
It can also be pushed up out of the
cut-out from below. It must be
pushed up from the back first.
29
Advertisement
Table of Contents
