before plugging in
Make sure your electricity supply is the same as the one shown
on the underside of your appliance.
Important – UK only
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
The appliance must be protected by a 13A approved (BS1362)
For non-rewireable plugs the fuse cover MUST be refitted when
replacing the fuse. If the fuse cover is lost then the plug must not
be used until a replacement can be obtained. The correct fuse
cover is identified by colour and a replacement may be obtained
from your Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED
IMMEDIATELY. An electric shock hazard may arise if an
unwanted non-rewireable plug is inadvertently inserted into a 13A
This appliance conforms to EC directive 2004/108/EC on
Electromagnetic Compatibility and EC regulation no. 1935/2004
of 27/10/2004 on materials intended for contact with food.
before using for the first time
1 Remove the plastic blade covers from the knife blade. Take
care the blades are very sharp. These covers should be
discarded as they are to protect the blade during manufacture
and transit only.
2 Wash the parts see 'care & cleaning'
bowl with drive shaft
detachable drive shaft
power on light
cord storage (at back)
A - standard attachment
max capacity disc
2mm slicing/grating disc
B - optional attachments
Not all the attachments listed below will be included with your food
processor model. Attachments are dependent upon the model
variant. For more information or to order additional attachments
refer to the "service and customer care" section.
dual whisk (if supplied)
4mm slicing/grating disc (if supplied)
extra fine grater disc (if supplied)
French fry disc (if supplied)
folding tool (if supplied)
mini bowl and blade (if supplied)
grinding mill (if supplied)
citrus juicer (if supplied)
juice extractor (if supplied)
attachment storage box (if supplied)
to use your food processor
1 Fit the bowl to the power unit. Place the handle towards the right
hand side and turn forward
2 Fit an attachment over the bowl drive shaft.
Note: Detachable drive shaft
using the discs, mini bowl, whisk, folding tool and
Always fit the bowl and attachment onto the processor before
3 Fit the lid ensuring the top of the drive shaft/tool locates into the
centre of the lid
The processor will not operate if the bowl or lid are
not fitted correctly into the interlock. Check that the
feed tube and bowl handle are situated to the right
hand front corner.
4 Plug in. The Power On light will come on. Select one of the
following options: -
Speed Control – manually select the required speed (refer to the
recommended speed chart).
Pulse – use the pulse (P) for short bursts. The pulse will operate
for as long as the control is held in position.
5 At the end of processing turn the speed control to the 'OFF'
position (Align the speed control with the power on light
Always switch off and unplug before removing the lid.
Your processor is not suitable for crushing or grinding coffee
beans, or converting granulated sugar to caster sugar.
until it locks.
should be fitted when