Step 2 - Connect Camera And Mobile Device - Uniden APPCAM 24HD Owner's Manual

2. Wireless Setup - Connect the camera to power After about 45 seconds,
the green LED begins to flash (3-flash/pause pattern), indicating that the
camera is in Pairing mode.
Wired Setup - Connect the camera to your router using the Ethernet
cable provided. Connect to power. After about 45 seconds, the green
LED begins to flash (3-flash/pause pattern), indicating that the camera is
in Pairing mode. Go to Step 2 in the next section, Connect Camera and
Mobile Device.

STEP 2 - CONNECT CAMERA AND MOBILE DEVICE

1. From your device's Settings, go to WiFi. Select the AppCam 24HD to
connect your device to it. The camera listing will be HD-XXXXXX where
XXXXXX are the last 6 digits on the camera label. Enter the default
password, 12345678, and tap Connect for Android or Join for iOS..
2. When the device is connected to the camera,
launch the app and tap the Add New System icon.
3. The System Information screen displays. Name the camera and tap Search.
4. The camera's DID should display. Tap the DID for
Android or Join for iOS.
10
Android iOS
Android
iOS