Table of Contents
Advertisement
6.5
Assembly of Parts
Arrange the horizontal member, left vertical member (left track), and right vertical member (right
track) on the floor in front of the clear opening as shown in Diagram 3. The curtain side of the
horizontal member and each vertical member faces down.
A
U-shaped
plate
Bolts & nuts
Clear Opening
At this end of members
Left vertical member
Placement of Parts for Assembly
Lay left track, right track, and horizontal
member face down in front of the clear opening
as shown.
Part No. 4801-5154 Rev 4-08
End of
B
horizontal
member
3/8" x 1"
Plate fits inside
vertical member
Slide vertical member
over U-shaped plate.
Vertical
Member
On each end of the horizontal member is a U-shaped
plate that fits inside each vertical member. The U-
shaped plate has four bolt holes, two on the inside
and two on the outside flanges that match bolt holes
in the vertical member. See diagram at left.
1. Align the vertical member with the U-shaped
metal plate at end of horizontal member.
2. Slide the vertical member onto the outside of the
U-shaped metal plate of the horizontal member
as shown in A.
3. Insert bolts through bolt holes as shown in B.
Install nuts. Tighten bolts & nuts securely.
Diagram 3
500 ST Door
Right vertical member
Horizontal member
Page 12 of 25
Advertisement
Table of Contents
