Storage; Replacement; Replacement Parts - Philips SC2001/01 Manual

1 Switch off the appliance, unplug it and let it cool down.
Note: The light exit window becomes hot during use. Make sure it has cooled
down before you clean it.
2 To remove the attachment, put your fingers in the recesses at the
top and bottom and pull gently. The attachment should come off
easily.
3 Moisten the soft cloth supplied with the appliance with a few drops
of water and use it to clean the following parts:
- the light exit window
- the outside surface of the attachment
- the metallic frame inside the attachment
Note: If water does not clean effectively, use a few drops of high-percentage
alcohol to clean the parts mentioned above.
Note: A contaminated light exit window and/or attachment can look like this
picture. Make sure you clean the appliance before and after each use and,
if necessary, also during the treatment according to the instructions in this
section.
Tip: If it is no longer possible to clean the edges of the attachment with the
enclosed cleaning cloth, use a cotton bud instead. Make sure that no fluff
or fibres stay behind on the attachment or on the light exit window.
4 If necessary, clean the outside of the appliance with the dry soft
cleaning cloth supplied with the appliance.

Storage

1 Switch off the appliance, unplug it and let it cool down.
2 Clean the appliance before you store it.
3 Put the appliance in the pouch supplied.
4 Store the appliance in a dry place at a temperature between 0°C and
60°C.

replacement

If you have to replace a part or want to purchase an additional part, go to
your Philips dealer or visit www.philips.com/support.
If you have problems obtaining the parts, please contact the Philips
Consumer Care Centre in your country.

replacement parts

The following replacement parts are available:
- Body attachment
- Adapter
- Pouch
EngliSh
21