Brother DCP-9055CDN Basic User's Manual page 89

Error Message
No Paper
No Permission
No Toner
No Tray
No Waste Toner
Not Available
Out of Memory
Print Unable XX
(XX=Error Code)
Cause
The machine is out of paper or
paper is not correctly loaded in
the paper tray.
You have attempted to print in
color using a Secure Function
Lock ID that is restricted to mono
printing only. The print job will be
cancelled.
The toner cartridge for the color
indicated on the LCD is not
installed correctly.
The paper tray indicated on the
LCD is not installed properly.
The waste toner box is not
installed properly.
The attempted function is
restricted by Secure Function
Lock 2.0.
The machine's memory is full.
The machine has a mechanical
problem.
Action
Do one of the following:
 Refill the paper in the paper tray.
 Remove the paper and load it again.
 If the problem is not resolved, the paper
pick-up roller may need to be cleaned.
Clean the paper pick-up roller. (See
Cleaning the paper pick-up rollers
on page 75.)
Contact your administrator to check your
Secure Function Lock Settings.
Pull out the drum unit. Take out the toner
cartridge for the color indicated on the LCD,
and then put it back into the drum unit.
Re-install the paper tray that is indicated on
the LCD.
Re-install the waste toner box. (See
Replacing the waste toner box on page 54.)
Contact your administrator to check your
Secure Function Lock Settings.
Do one of the following:
 Press Mono Start or Color Start to copy
the scanned pages. (Copy operation in
progress)
 Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Reduce print quality. (See Advanced tab

in the Software User's Guide.)
 Add optional memory. (See Memory
board in Appendix B of the Advanced
User's Guide.)
Do one of the following:
 Turn the power switch off, wait a few
minutes, and then turn it on again.
 If the problem continues, call your
Brother dealer.
Troubleshooting
B
81