Table of Contents
Advertisement
6. Operation
6-1 Operation settings for Wideband True Diversity Receiver //
UF-20R/UF-20S
6-1-1. Turn the receiver power on.
(1) Install the receiver antenna.
(2) Push the power button
to turn
1
the power on
(3)To turn off: push and hold the power
button till the display shows
"Power Off. "
6-1-2. REMOSET function:
(1) Push the REMOSET button and the blue indicator starts to flash, indicating the receiver
is transmitting data (Figure 1).
*When using the REMOSET function of UF-20R, it is recommended to carry out RE-
MOSET one by one. This is to prevent the interference between the REMOSET signals
and the failure of data transmitting.
29
Professional Wideband True Diversity System (75MHz)
UF-20R
PUSH
/ CONTROL
wireless receiver
SETUP
EXIT
Figure 1
(2) REMOSET successful: the blue indicator on the transmitter is on for 3 seconds and that
on the receiver stops flashing.
(3)REMOSET failed: Check the following when the blue indicator on the receiver flashes in
a slow pace:
1)If the receiver and the transmitter are of the same frequency band.
2)The "Remoset Function" on in the function menu of Transmitter is "activated;"
3)The "Device ID" is the same on both the receiver and transmitter.
4)The transmitter battery is low (synchronization is not possible if it is too low).
Notes:
(1)For receiver settings, please see: "6. Device ID" and "7. Microphone Setting" of 6-1
Operation settings for Wideband True Diversity Receiver.
(2)For handheld transmitter settings, please see: "5. Device ID" and "6. Remoset
Function" of 6.2 Operation settings for handheld transmitter system.
(3)For body-pack transmitter settings, please see: "5. Device ID" and "6. Remoset
Function" of 6.3 Operation settings for body-pack transmitter system.
Fig. 2
30
Hide quick links:
Advertisement
Table of Contents
