16-36 ELECTRICAL SYSTEM
Replace the O-ring [A] of the lower water pipe [B] with a
Apply soap and water solution to the new O-ring.
For VN1700A9F/B9F models, insert the lower water pipe
[A] into the alternator cover [B] before install the alternator
Install the alternator cover.
Do not pinch the alternator, crankshaft sensor
and sidestand switch leads between the alternator
cover and the crankcase.
Alternator Cover Bolts [B] L = 70 mm (2.8 in.)
Alternator Cover Bolts [C] L = 50 mm (2.0 in.)
Torque - Alternator Cover Bolts: 12 N·m (1.2 kgf·m, 106
Run the leads correctly (see Cable, Wire and Hose Rout-
ing section in the Appendix chapter).
Install the removed parts (see appropriate chapters).
Alternator Stator Coil Removal
Alternator Cover (see Alternator Cover Removal)
Holding Plate Bolt [A] and Plate
Alternator Lead Grommet [B]
Alternator Stator Coil Mounting Bolts [A]
Alternator Stator Coil [B]