K-ACT ABS (Equipped Models)
Rear Wheel Rotation Sensor Removal
The wheel rotation sensor should be handled care-
fully, never struck sharply with a hammer, or al-
lowed to fall on a hard surface since the wheel rota-
tion sensor is precision made. Be careful not to get
water or mud on the wheel rotation sensor.
Do not try to disassemble or repair the wheel rota-
Right Lower Side Cover (see Right Side Cover Removal
in the Frame chapter)
Right Saddlebag (see Saddlebag Removal in the Frame
Connector [A] (Disconnect)
Rear Wheel Rotation Sensor [D]
Rear Wheel Rotation Sensor Installation
Installation is the reverse of removal.
Run the lead correctly (see Cable, Wire, and Hose Rout-
ing section in the Appendix chapter).
Wheel Rotation Sensor Inspection
Remove the front wheel rotation sensor [A] from the sen-
Remove the rear wheel rotation sensor [B] from the
Visually inspect the wheel rotation sensors.
Replace the wheel rotation sensor if it is cracked, bent, or