K-ACT ABS (Equipped Models)
K-ACT ABS Hydraulic Unit Removal
The K-ACT ABS hydraulic unit [A] has been ad-
justed and set with precision at the factory. There-
fore, it should be handled carefully, never struck
sharply with a hammer, or allowed to fall on a hard
Be careful not to get water or mud on the K-ACT
ABS hydraulic unit.
Drain the brake fluid from the front and rear brake lines.
Drain the brake fluid through the bleed valve by pumping
the brake lever and pedal.
Right Side Cover (see Right Side Cover Removal in the
Right Lower Side Cover (see Right Side Cover Removal
in the Frame chapter)
Battery Case Cover (see Battery Removal in the Electri-
cal System chapter)
Clean the K-ACT ABS hydraulic unit.
Clean all fittings on the K-ACT ABS hydraulic unit
and the rear master cylinder because dirt around
the banjo bolts could contaminate the brake fluid in
the line during removal/installation.
Spread out a shop towel around the K-ACT ABS hy-
draulic unit before removing the brake line so that
brake fluid does not leak on the parts.
Disconnect the sensor connectors [A].
Disconnect the ECU connector [B].
Push [C] the connector, and pull down the lever [D].
Disconnect the sensor connector [A].