Lubrication Points And Types Of Lubricant; Tightening Torque - Hitachi G 18SE3 Technical Data And Service Manual

The internal wire with tube of stator shall pass this groove.
(6) Mount the cord clip as shown in Fig. 17 being careful of the direction.

8-3. Lubrication Points and Types of Lubricant

Pinion chamber of Gear Cover Ass'y [5] <5> (5) ................... ALVANIA grease EP (LF) O 35 g

8-4. Tightening Torque

Tapping Screws (W/Flange) D4 x 16
[49] <48> (49) [57] <57> (58) ......................................................... 2.0
Seal Lock Screws (W/Sp. Washer) M5 x 14 [1] <1> (1) ................. 2.9
Tapping Screw (W/Flange) D5 x 35 [2] <2> (2) .............................. 3.4
Hex. Socket Hd. Bolt (W/Flange) M5 x 16 [28] <28> (28) .............. 7.8
Special Nut M10 [6] <6> (6) ........................................................... 15.3
Machine Screw M5 x 10 [21] <21> (21) ......................................... 5.9
Cord dia.: Over 8.5 mm dia.
Cord clip mounting diag.
Fig. 16
Cord dia.: Max. 8.5 mm dia.
Fig. 17
Generously rub grease onto the gear and pinion
and inner circumference of metal.
0.5 N
0.5 N
0.7 N
1.5 N
3.1 N
1.5 N
--- 17 ---
The internal wire of stator
shall pass this area. (2 pcs.)
m (20 5 kgf cm, 1.5
• •
m (30 5 kgf cm, 2.2
• •
m (35 7 kgf cm, 2.5
• •
m (80 15 kgf cm, 5.8
• •
m (150 30 kgf cm, 10.8
• •
m (60 15 kgf cm, 4.3
• •
0.4 ft-lbs.)
0.4 ft-lbs.)
0.5 ft-lbs.)
1.1 ft-lbs.)
2.2 ft-lbs.)
1.1 ft-lbs.)