Administration - For Applock; Introduction - Honeywell MX9 Reference Manual

Microsoft windows mobile 6.5 operating system
Hide thumbs Also See for MX9:
Table of Contents

Advertisement

Administration - for AppLock

Introduction

AppLock is designed to be run on Windows based devices only. The AppLock program is installed before shipping.
MX9 AppLock is setup by the Administrator by tapping Start > Settings > System > Administration.
Configuration parameters are specified by the AppLock Administrator for the MX9 end-user. AppLock is password protected by
the Administrator.
End-user mode locks the end-user into the configured application or applications. The end user can still reboot the mobile
device and respond to dialog boxes. The administrator-specified applications are automatically launched in the specified order
and run in full screen mode when the MX9 boots up.
When the mobile device is reset to factory default values, for example after a cold reset, the Administrator may need to
reconfigure the AppLock parameters.
The assumption, in this section, is that the first user to power up a new mobile device is the system administrator.
Note:
AppLock Administrator panel file Launch option does not inter-relate with similarly-named options contained in other
MX9 System Panels.
Note:
A few applications do not follow normal procedures when closing. AppLock cannot prevent this type of application
from closing, but is notified that the application has closed. For these applications, AppLock immediately restarts the
application (see Auto Re-Launch) which causes the screen to flicker. If this type of application is being locked, the
administrator should close all other applications before switching to end-user mode to minimize the screen flicker.
AppLock is updated periodically as new options become available. Contact
availability.
technical assistance
for downloads and update
4-47

Advertisement

Table of Contents
loading

Table of Contents