Troubleshooting Guide - Panasonic SC-PT22 Operating Instructions Manual

Dvd home theater sound system
Table of Contents

Advertisement

Troubleshooting guide

Before requesting service, make the following checks. If you are in doubt
about some of the check points, or if the solutions indicated in the following
guide do not solve the problem, consult your dealer for instructions.
Power
No power.
Insert the AC mains lead securely. (
The unit is automatically switched to standby mode.
≥ The Sleep timer was working and had reached the set time limit. (
≥ The Auto AUX link was working. (
Unit displays
The display is dark.
Select "BRIGHT" in "FL DIMMER" in the OTHERS menu. (
"NO PLAY"
≥ You inserted a disc the unit cannot play; insert one it can. (
≥ You inserted a blank disc.
≥ You inserted a disc that has not been finalised.
"NO DISC"
≥ You have not inserted a disc; insert one.
≥ You have not inserted the disc correctly; insert it correctly. (
"OVER CURRENT ERROR"
The USB device is drawing too much power. Switch to "DVD/CD" mode,
remove the USB and turn the unit off.
"F61"
Check and correct the speaker cable connections. If this does not fix the
problem, consult the dealer. (
"F76"
There is a power supply problem. Consult the dealer.
"DVD U11"
Disc may be dirty. Wipe it clean.
"ERROR"
Incorrect operation performed. Read the instructions and try again.
"DVD H∑∑"
"DVD F∑∑∑"
∑ stands for a number.
≥ Trouble may have occurred. The numbers following "H" and "F" depend
on the status of the unit. Turn the unit off and then back on.
Alternatively, turn the unit off, disconnect the AC mains lead, and then
reconnect it.
≥ If the service numbers fail to clear, note the service number and contact
a qualified service person.
"REMOTE 1" or "REMOTE 2"
Match the modes on the main unit and remote control. Depending on the
number being displayed ("1" or "2"), press and hold [OK] and the
corresponding numbered button ([1] or [2]) for at least 2 seconds. (
7)
9)
15)
17)
6)
General operation
No response when any buttons are pressed.
≥ This unit cannot play discs other than the ones listed in these operating
instructions. (
≥ The unit may not be operating properly due to lightning, static electricity
or some other external factor. Turn the unit off and then back on.
Alternatively, turn the unit off, disconnect the AC mains lead, and then
reconnect it.
≥ Condensation has formed. Wait 1 to 2 hours for it to evaporate.
No response when remote control buttons are pressed.
≥ Check that the batteries are installed correctly. (
5)
≥ The batteries are depleted. Replace them with new ones. (
≥ Aim the remote control at the remote control signal sensor and operate.
(
5)
Other products respond to the remote control.
Change the remote control operating mode. (
No picture or sound.
≥ Check the video or speaker connection. (
≥ Check the power or input setting of the connected equipment and the
main unit.
≥ Check that the disc has something recorded on it.
You have forgotten your ratings password.
Reset all the settings to Factory Preset.
11)
While stopped and "DVD/CD" is the source, press and hold [∫] (Stop) on
the main unit and [S10] on the remote control until "INITIALIZED"
disappears from the TV. Turn the unit off and on again.
All settings will return to the default values.
(This does not work during program and random modes, or when setup
menu or START menu is displayed.)
Some characters are not displayed correctly.
Characters other than English alphabet and Arabic numerals may not be
displayed correctly.
Disc operation
It takes time before play starts.
≥ Play may take time to begin when an MP3 track has still picture data.
Even after the track starts, the correct play time will not be displayed.
This is normal. [MP3]
≥ This is normal on DivX video. [DivX]
A menu screen appears during skip or search.
This is normal for Video CDs.
Playback control menu does not appear.
[VCD] with playback control
Press [∫ STOP] twice and then press [1 PLAY].
Program and Random play do not work.
These functions do not work with some DVD-Videos.
Play does not start.
≥ This unit may not play MPEG4 that contains still picture data.
≥ If playing DivX VOD content, refer to the homepage where you
5)
purchased the DivX VOD content. (Example: www.divx.com/vod) [DivX]
≥ If a disc contains CD-DA and other formats, proper playback may not be
possible.
No subtitles.
≥ Display the subtitles. ("SUBTITLE" in Menu 1) (
≥ Subtitles may not be displayed depending on the disc. [DivX]
Point B is automatically set.
The end of an item becomes point B when it is reached.
The Setup menu cannot be accessed.
≥ Select "DVD/CD" as the source.
≥ Cancel Program and Random play. (
17)
5)
6, 7)
11)
8)
8)
[VCD]
[DVD-V]
13)
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents