Before You Call For Service - Maytag CRE9900ACB Owner's Manual

BEFORE YOU CALL FOR SERVICE
Cheek these points if.., • ls there 1 to 2 inches of space be_,een pans
and the oven walls? Are the range and oven
Part or all of your electric range does not racks level?
operate
• Is the range plug loose or disconnected f?om • Was good cool_are/bakeware of the proper
size used?
tile electrical outlet (if not wired direct to
tile electrical supply)? • Are you using a tested recipe from a reliable
sonrce? The
oven therlnustat on
your new
• Are any house fhses blo_n_ or circuit
range may be more accurate than the one on
breakers tripped? your old range.
• }Ias a range fuse blox_m(Canadian ranges • \,Vastile oven vent covered or blocked on
nnly)? the range surfhcc ?
• lias the power supply to the home heen
interrupted? Food does not broil properly
• Are the oven controls properly set? • Are the controls fi_rbroiling set properly?
• Was the electronic control (select models) (see Broiling section)
correctly set? • Was the proper rack position used? (see
• Was the door left in the locked position Broiling section)
tbllowing a self-clean cycle? (select models) • Did you allow time for the broil element to
• Is the oven set for delay start? (select preheat?
models) • Was the broiler pan received with the range
used?
Surfaee elements fall to turn on or heat
• \_k_sahunimun foil used on tile broiler pan
the food properly insert, hlocking the slits for fat drainage?
• Is the range plug loose or disconnected fk_m
the electrical outlet (if not wired direct to Oven light does not operate
the electrical supply)? • Is the bulb loose or burned out?
• 11as a range fuse blown (Canadian ranges • Is the light switch in the On positiorf?
only)? Oven will not self-clean (select models)
• If the range has coil elements, are they ° Is the self2elean control set properly? (see
properl) plugged into the receptacles? Self-Clean instructions)
• Were appropriate utensils used? (See • Is the oven set fur delay start?
CookwareSection)
Oven door won't latch (select models)
• Are the surfhce element controls properly
set? • Are tile proper controls set fur the self-clean
cycle? (see Self Clean instructions).
• Is the self-clean cycle operating and
therefore overriding tile surface eoukmg Oven door wiU not unlock (select models)
abilities (Canadian ranges only')? • llas the sell:-clean cycle been finished tbr at
Food not baMng correctly least one hour?
• Are the o_en racks properly placed for "F" plus a number appears in the display
baking? (see Baking Chart) (seleet models)
• Have you used ahnninum foil eorrectl). • These are fault codes, lfa fault code appears
• Was the oven preheated as recommended? in the display and a continuous beep sounds,
• Are the controls for bake operations press the CANCEL button. If the fhult code
properly set? reappears, disconnect power to the range
and call a qualified sen'ice technician.
PAGE 24