16-82 ELECTRICAL SYSTEM
30 A Main Fuse Removal
Remove the starter relay (see Starter Relay Inspection).
Slide out the cap [A].
Open the cover [B], and pull out the main fuse [C] straight
out of the fuse box with needle nose pliers.
Fuse Box Fuse Removal
Remove the fuel tank (see Fuel Tank Removal in the Fuel
System (DFI) chapter).
Open the lids [A].
Pull out the fuses [A] straight out of the fuse box with
needle nose pliers.
If a fuse fails during operation, inspect the electrical sys-
tem to determine the cause, and then replace it with a
new fuse of proper amperage.
Install the fuse box fuses on the original position as spec-
ified on the lid.
Remove the fuse (see 30 A Main Fuse/Fuse Box Fuse
Inspect the fuse element.
If it is blown out, replace the fuse. Before replacing a
blown fuse, always check the amperage in the affected
circuit. If the amperage is equal to or greater than the
fuse rating, check the wiring and related components for
a short circuit.
Fuse Element [B]
Blown Element [D]
When replacing a fuse, be sure the new fuse
matches the specified fuse rating for that circuit.
Installation of a fuse with a higher rating may cause
damage to wiring and components.