Swingarm Bearing, Sleeve Inspection
Do not remove the bearings for inspection. Re-
moval may damage them.
Inspect the needle bearings [A] and ball bearing installed
in the swingarm.
The rollers and ball in a bearing normally wear very little,
and wear is difficult to measure. Instead of measuring,
visually inspect the bearing for abrasion, discoloration, or
If the needle bearings and sleeves [B] show any sings of
abnormal wear, discoloration, or damage, replace them
as a set.
Turn the bearing in the swingarm back and forth [A] while
checking for plays, roughness, or binding.
If bearing play, roughness, or binding is found, replace
Inspect the bearing seal [B] for tears or leakage.
If the seal is torn or is leaking, replace the bearing.
Swingarm Bearing Lubrication
Since the bearings are packed with grease and sealed,
lubrication is not required.
Chain Guide Inspection
Refer to the Chain Guide Wear Inspection in the Periodic