Anti-Lock Brake System (Equipped Models)
Do the 4th step test as follows.
Check the battery terminal voltage between the red/white
lead terminal of the fuse box [A] and ground.
Special Tool - Hand Tester: 57001-1394
Battery Terminal Voltage
If the battery terminal voltage is not within the specifica-
tion, go to the 5th step.
If the battery terminal voltage is correct, go to the 6th step.
Do the 5th step test as follows.
Check for continuity between the positive (+) cable [A] of
the battery and red/white lead terminal of the main har-
ness side connector (ABS hydraulic unit) [B].
If there is the continuity in the lead, go to the 4th step.
If there is not the continuity in the lead, replace or repair
the main harness.
Do the 6th step test as follows.
Recheck the service code indication; erase the service
code, perform the pre-diagnosis inspection 1 and 2, and
retrieve the service code.
If the yellow ABS indicator light (LED) [A] goes on, faulty
ABS motor relay in the ABS hydraulic unit. Replace the
ABS hydraulic unit.
If the yellow ABS indicator light (LED) does not go on,
ABS system is normal (service code is not stored; tempo-
Front Wheel Rotation Sensor Signal Abnormal
(Service Code 42)
Do the 1st step test as follows.
Measure the air gap between the front wheel rotation sen-
sor and sensor rotor.
Thickness Gauge [A]
Front Wheel Rotation Sensor Air Gap
Standard: 0.3 ∼ 1.7 mm (0.01 ∼ 0.07 in.)
If the measurement is over standard, check each part
for deformation and looseness and correct accordingly.
Recheck the air gap.
If the measurement is correct, go to the 2nd step.