Anti-Lock Brake System (Equipped Models)
Remove the front seat (see Front Seat Removal in the
Ground the self-diagnosis terminal [A] (Gray) to the bat-
tery (–) terminal or battery (–) cable connector, using a
Turn the ignition switch to ON.
Count the blinks of the yellow ABS indicator light (LED)
to read the service code. Keep the auxiliary lead ground
until you finish reading the service code.
Service Code Clearing Procedures
Start the service code erase mode with the following pro-
The erase mode starts when the ABS self-diagnosis ter-
minal is disconnected from the ground terminal after start-
ing the self-diagnosis mode.
The service code can be erased by grounding and un-
grounding (each time for at least 1 second) the ABS self
-diagnosis terminal 3 times or more within about 12.5 sec-
onds after starting the erase mode.
The yellow ABS indicator light (LED) stays on during the
erase mode and after erasing.
Once erasing is finished, enter the self-diagnosis mode
again to confirm that the service codes have been
erased. If the ABS has been reset and all codes have
been erased, only start code 12 will be shown.