Be sure that the dowel pins [A] are in position.
Install the speed sensor bracket and tighten the bolts.
Torque - Speed Sensor Bracket Bolts: 9.8 N·m (1.0 kgf·m,
Run the leads and hoses correctly (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
Install the engine sprocket cover and tighten the bolts.
Torque - Engine Sprocket Cover Bolts: 9.8 N·m (1.0 kgf·m,
Install the left frame cover (see Frame Cover Installation
in the Frame chapter).
Adjust the drive chain slack (see Drive Chain Slack Ad-
justment in the Periodic Maintenance chapter).
Rear Sprocket Removal
Remove the rear wheel (see Rear Wheel Removal in the
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place blocks to under the wheel so that the disc
does not touch the ground.
Rear Sprocket Nuts [A]
Rear Sprocket [B]
Rear Sprocket Installation
Install the sprocket with the tooth number marking [A] fac-
Replace the rear sprocket nuts with new ones.
Torque - Rear Sprocket Nuts: 59 N·m (6.0 kgf·m, 44 ft·lb)
Install the rear wheel (see Rear Wheel Installation in the
Apply high-temperature grease to the following portions.
Coupling Grease Seal Lips [A]
Coupling Internal Surface [B]
FINAL DRIVE 11-11