Cotter Pin [A]
Rear Axle Nut [B]
Rear Axle [D] (from Right Side)
Remove the drive chain [A] from the rear sprocket toward
Move the rear wheel back and remove it.
Do not lay the wheel on the ground with the disc
facing down. This can damage or warp the disc.
Place wooden blocks under the wheel so that the
disc does not touch the ground.
Rear Wheel Installation
Apply high-temperature grease to the grease seal lips.
Fit the collars on the both sides of the hub.
Left Side Collar [A]
Right Side Collar [B] (with Flange)
Engage the drive chain with the rear sprocket.
Install the caliper bracket [A] onto the stopper [B] of the
Insert the rear axle from the right side of the wheel.
Install the washer and rear axle nut.
Adjust the drive chain slack before tightening the rear
axle nut (see Drive Chain Slack Inspection in the Periodic
Torque - Rear Axle Nut: 108 N·m (11.0 kgf·m, 80 ft·lb)
Insert a new cotter pin [A].
When inserting the cotter pin, if the slots in the nut do
not align with the cotter pin hole in the axle, tighten the
nut clockwise [B] up to next alignment.
It should be within 30 degrees.
Loosen once and tighten again when the slot goes past
the nearest hole.