Install the washer so that the OUT SIDE mark [A] faces
Replace the clutch hub nut [A] with a new one.
Hold the clutch hub [B] steady with the clutch holder [C],
and tighten the clutch hub nut.
Special Tool - Clutch Holder: 57001-1243
Torque - Clutch Hub Nut: 130 N·m (13.3 kgf·m, 96 ft·lb)
Install the friction plates and steel plates, starting with a
friction plate and alternating them.
If new dry friction plates and steel plates are in-
stalled, apply engine oil to the surfaces of each
plate to avoid clutch plate seizure.
Install the last friction plate [A] fitting the tangs [B] in the
grooves in the housing as shown in the figure.
Apply molybdenum disulfide grease to the pusher end [A].
Install the pusher [B] into the drive shaft [C].
Apply engine oil to the sliding surfaces of the bearing [A].
Install the spring plate [B] on the clutch hub [C].
Clutch Spring Bolts and Washers
Torque - Clutch Spring Bolts: 9.8 N·m (1.0 kgf·m, 87 in·lb)
Install the clutch cover (see Clutch Cover Installation).