Cylinder Head Removal
Engine Oil (see Engine Oil Change in the Periodic Main-
Coolant (see Coolant Change in the Periodic Mainte-
Muffler (see Muffler Removal)
Cylinder Head Cover (see Cylinder Head Cover Re-
Camshafts (see Camshaft Removal)
Throttle Body Assy (see Throttle Body Assy Removal in
the Fuel System (DFI) chapter)
Throttle Body Assy Holders (see Throttle Body Assy
Water Hose [A]
Front Camshaft Chain Guide [B]
Water Temperature Sensor Connector [C]
Firstly remove the M6 cylinder head bolts [A].
Secondly remove the M6 cylinder bolts [B].
Thirdly remove the M8 cylinder bolt [C].
Fourthly remove the M10 cylinder nut [D].
Lastly remove the M10 cylinder head bolts [E].
Take off the cylinder head.
Cylinder Head Installation
The camshaft cap is machined with the cylinder head,
so if a new cylinder head is installed, use the cap that
is supplied with the new head.
Be sure that the dowel pins [A] are in position.
Install a new cylinder head gasket.
Install the cylinder head onto the cylinder.
ENGINE TOP END 5-27