Push and pull [A] the hose joint [B] back and forth more
than 2 times and make sure it is locked and does not come
Leaking fuel can cause a fire or explosion resulting
in serious burns. Make sure the hose joint is in-
stalled correctly on the delivery pipe by sliding the
If it comes off, reinstall the hose joint.
Connect the fuel pump lead connector and the battery (–)
Install the other removed parts (see appropriate chap-
Install the fuel tank cover [A] so that the projections [B] fit
into the grommets [C].
Run the hose and lead correctly (see Cable, Wire, and
Hose Routing section in the Appendix chapter).
Fuel Tank and Cap Inspection
Visually inspect the gasket [A] on the tank cap for any
Replace the gasket if it is damaged.
Check to see if the water drain pipe [B] and fuel breather
pipe [C] in the tank is not clogged. Check the tank cap
If they are clogged, remove the tank and drain it, and then
blow the breather free with compressed air.
Do not apply compressed air to the air vent holes
[D] in the tank cap. This could cause damage and
clogging of the labyrinth in the cap.
FUEL SYSTEM (DFI) 3-111