3-110 FUEL SYSTEM (DFI)
Turn the driver [A] to disconnect the joint lock [B].
Pull the fuel hose joint [C] out of the outlet pipe [D].
Fuel is flammable and explosive under certain con-
ditions and can cause severe burns. Be prepared
for fuel spillage; any spilled fuel must be completely
wiped up immediately. When the fuel hose is dis-
connected, fuel spills out from the hose and the
pipe because of residual pressure. Cover the hose
connection with a piece of clean cloth to prevent
Close the fuel tank cap.
Remove the fuel tank [A], and place it on plank [B].
Do not apply the load to the fuel outlet pipe [C] of the fuel
Fuel Tank Installation
Note the above WARNING (see Fuel Tank Removal).
Check that the rubber dampers [A] are on the frame and
the fuel tank.
If the dampers are damaged or deteriorated, replace them
with new ones.
Insert the fuel hose joint [A] straight onto the outlet pipe
until the hose joint clicks.
When installing the fuel hose joint, do not apply
strong force to the outlet pipe on the fuel pump. The
pipe made from resin could be damaged.
Push the joint lock [B] until it clicks.