Entering System Setup; Responding To Error Messages; Using The System Setup Navigation Keys - Dell PowerEdge R920 Owner's Manual

Hide thumbs Also See for PowerEdge R920:
Table of Contents

Advertisement

UEFI boot mode is an enhanced 64-bit boot interface based on Unified Extensible Firmware Interface (UEFI)
specifications that overlays the system BIOS.
You must select the boot mode in the Boot Mode field of the Boot Settings screen of System Setup. Once you specify the
boot mode, the system boots in the specified boot mode and you then proceed to install your operating system from that
mode. Thereafter, you must boot the system in the same boot mode (BIOS or UEFI) to access the installed operating
system. Trying to boot the operating system from the other boot mode will cause the system to halt at startup.
NOTE: Operating systems must be UEFI-compatible to be installed from the UEFI boot mode. DOS and 32-bit
operating systems do not support UEFI and can only be installed from the BIOS boot mode.
NOTE: For the latest information on supported operating systems, go to dell.com/ossupport.

Entering System Setup

1.
Turn on or restart your system.
2.
Press <F2> immediately after you see the following message:
<F2> = System Setup
If your operating system begins to load before you press <F2>, allow the system to finish booting, and then restart
your system and try again.

Responding To Error Messages

If an error message is displayed while the system is booting, make a note of the message. For more information, see
System Error Messages.
NOTE: After installing a memory upgrade, it is normal for your system to display a message the first time you start
your system.

Using The System Setup Navigation Keys

Keys
Action
Up arrow
Moves to the previous field.
Down arrow
Moves to the next field.
<Enter>
Allows you to type in a value in the selected field (if applicable) or follow the link in the field.
Spacebar
Expands or collapses a drop-down menu, if applicable.
<Tab>
Moves to the next focus area.
<Esc>
Moves to the previous page till you view the main screen. Pressing <Esc> in the main screen
displays a message that prompts you to save any unsaved changes and restarts the system.
<F1>
Displays the System Setup help file.
20
NOTE: For the standard graphics browser only.
NOTE: For most of the options, any changes that you make are recorded but do not take
effect until you restart the system.

Advertisement

Table of Contents
loading

Table of Contents