Table of Contents
Advertisement
Handle
Alignment
Holes
Frame
Assy.
STeP 1: Attach the handle to the
frame of the pressure washer. Note:
It may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
Safety
latch
High Pressure
Hose
STeP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
High Pressure Hose
Pump
discharge
Fitting
STeP 7: Connect high pressure
hose to pump discharge fitting.
Push coupler collar forward until
secure.
STeP 9: Connect the garden hose to pump water inlet.
Inspect inlet screen. CAUTION: Do not run the pump
without water or pump damage will result.
ASSeMblY INSTRUCTIoNS
Carriage
bolt
Washer
STeP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts.
Spray
Pressure
gun
Nozzle
STeP 5: Pull the spring-loaded
collar of the wand coupler back
to insert your choice of pressure
nozzle.
Cold
Water
Source
Coupler
Collar
garden
Hose
STeP 8: Connect garden hose to a
clean cold water source and open
supply valve completely. NEVER
use hot water.
garden
Hose
Inlet Screen
Pump
Water Inlet
9.800-083.0 • REV. 11/06
bolts
Nut
STeP 3: Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
Pressure
Nozzle
Wand
Coupler
STeP 6: Release the coupler col-
lar and push the nozzle and the
collar until the collar clicks or locks.
Pull the nozzle to make sure it is
secure.
Hose/Spray gun
Storage bracket
Nut
Studs
Wand
Coupler
Wand
Collar
7
Advertisement
Table of Contents
