WHEEL HEIGHT ADJUSTMENT
(FIGURE 8)
1. BEFORE MAKING
ANY ADJUSTMENTS,
TURN OFF, WAIT FOR
BLADE TO STOP AND UNPLUG
MOWER.
2. Your mower features the Black & Decker single lever wheel height
adjust system. This system will adjust all four wheels at the same
time. Mower adjusts from 1 to 3 1/2 in. (25.4mm
- 88.9mm)
with six
increments.
3. Place your left hand on the height adjust handle and your right hand
on the lower handle as shown in Figure 8.
4.
Pull height adjust handle away from mower, and re-set in the
desired height adjust position.
(See recommended
cutting height by
grass type under OPERATING
INSTRUCTIONS)
Rotating the
height adjust towards the front of the mower lowers the cutting
height, and rotating towards the rear raises the cutting height.
O
CUTTING HEIGHT POSITIONS
Position
Cut
1 (LOW)
1 in. (25.4mm)
2
1-1/2 in. (38.1mm)
3
2 in. (50.8mm)
4
2-1/2 in. (63.5mm)
LOW
5
3 in. (76.2mm)
6 (HIGH)
3-1/2 in. (88.9mm)
HIGH
DISCHARGING
The mower is designed
to disperse
the clippings back to the lawn.
1. Discharging
may be necessary
if the grass fills the optional bag too
quickly.
2. Clippings may be further dispersed,
if needed, by blowing them with
a yard blower.
3. In heavy grass conditions,
a narrower
pass may be required
Z_CAUTION:
Do not attempt to unclog the blade chamber
by
dropping or tapping the mower on the ground. This can damage the
mower.
OPTIONAL
GRASS BAG (AVAILABLE AS AN OPTION AT EXTRA
COST)
It is recommended
to bag the clippings
for the first few spring
mowings
and the last mowing of the season to discourage
diseases.
1. Bagging the clipping is sometimes
preferred
to reduce tracking of
clippings into pools, hot tubs, and homes.
2. Clippings can be added to your compost
bin and used later for a
natural fertilizer.
CLEANING AND STORAGE
Z_ DANGER: Be sure the mower is unplugged and the blade has
stopped.
Remove and clean any debris from the outside of the mower and
inside of guard before storage. Store under cover. See
MAINTENANCE
section.
Cleaning out the underside of the mower is done easiest immediately
after mowing (ENSURE MOWER
IS UNPLUGGED
AND BLADE HAS
STOPPED). A rag, crumpled newspaper
or paper towels, can be used
to wipe out caked clippings. Be careful of sharp edges of blade.
A clean mowing deck improves the efficiency of the blade and
maintains high performance.
When cleaning, DO NOT immerse mower
in water or squirt it with a hose or pressure washer. Use only mild soap
and damp cloth to clean the mower. Never let any liquid get inside the
mower; never immerse any part of the mower into a liquid.
NOTE:
Do not store the mower on or adjacent to fertilizers or
chemicals.
Such storage can cause rapid corrosion to metal parts.