LG PW700 Owner's Manual page 4

4
SAFETY INSTRUCTIONS
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Indoor Installation
WARNING
Do not use the projector outside and
y
do not expose the product to any
humidity or water.
- Since the product is not waterproof,
this may result in a fire or electric
shock.
Do not place the projector in direct
y
sunlight or near heat sources such as
radiators, fires, stoves, etc.
- This may result in fire.
Do not place flammable materials
y
such as aerosols near the projector.
- This may result in fire.
Do not allow children to cling to or
y
climb up to the projector.
- This may cause the projector to fall,
causing injury or death.
Do not install the product in a place with
y
no ventilation (e.g., on a bookshelf or in
a closet) or on a carpet or cushion.
- This may result in fire due to the
increase in internal temperature.
Do not place the product close to
y
sources of steam, oil or oil mist, such
as humidifiers and kitchen counters.
- Failure to do so may result in fire,
electric shock, or corrosion.
Do not install the product onto a wall
y
or ceiling that is close to sources of
oil or oil mist.
- The product may be damaged and
fall, resulting in serious injury.
Do not place the projector where it
y
might be exposed to dust.
- This may result in fire.
Do not use the projector in a damp
y
place such as a bathroom where it is
likely to get wet.
- This may result in fire or electric
shock.
Do not allow a tablecloth or curtain to
y
block the air vent.
- This may result in fire due to the
increase in the internal temperature.
Ensure good ventilation around the
y
projector. The distance between the
projector and the wall should be at
least 30 cm.
- This will prevent fire due to the
increase in the internal temperature.
CAUTION
When placing the projector on a table
y
or shelf, be careful not to put it near
the edge.
- The projector could fall due to
balance problems, which may
cause personal injury or damage to
the product. Make sure to use the
projector cabinet or stand that fits the
projector.
When moving the projector, make
y
sure to switch it off and remove the
power plug and cords.
- The power cord may be damaged,
resulting in fire or electric shock.
Do not place the projector on an
y
unstable or vibrating surface such as
a wobbly shelf or a slope.
- It may fall and cause injury.