Settings Menus; Set Backlight - Uniden BCD325P2 Owner's Manual

When you select 'AUTO' for a channel or mode's modulation or step, the above
values are used unless you've edited the Band Defaults. Although TV bands are
listed, the scanner cannot decode digital TV audio.

SETTINGS MENUS

To Edit Settings press Menu.
Scroll to 'Settings' and press E/yes.
Scroll to the settings and options below (in Blue) and press E/yes.

Set Backlight

Adjust Key
Beep
Battery Option
Adjust Contrast
Set C-CH
Output
Set Backlight
To use the backlight press
3 light intensities.
1. Scroll to 'Set Backlight' and press E/yes.
At 'Set Mode' press E/yes.
2.
3. Scroll to 1 of 5 settings and press E/yes to save and exit.
10 sec - The backlight stays on for 10 seconds after you press
30 sec - The backlight stays on for 30 seconds after you press
Squelch - The backlight turns on when the squelch opens then stays on
for 5 seconds.
Keypress - The backlight turns on when any key is pressed then stays
on for 10 seconds.
Infinite - The backlight turns on when you press
until you press
Scroll to 'Set Dimmer' and press E/yes.
4.
Scroll to 'High', 'Middle', 'Low' or 'Off' and press E/yes to save and exit.
5. Press Menu to return.
Set GPS Format
Set GPS Baud Rate
Band Default
P25 LP Filter
Disp. Unit ID
. There are 5 different ways to use the backlight and
again.
36
See Scanner Info
Locking/Unlocking the
Keypad
Viewing Battery level
Cloning
Scanner Reset
then stays on
.
.