Using Fire Tone-Out; Setting Up Tone-Out - Uniden BCD325P2 Owner's Manual

Note: You can also turn on weather alert in scan or search modes by pressing
and holding the WX button. Press WX again, then scroll to 'Alert Only', 'SAME
1-5', or 'All FIP' and press E/yes.
1. Scroll to 'Weather Alert' and press E/yes.
2. Scroll to 1 of 7 options and press E/yes.
Alert Only - the scanner immediately sounds a weather alert siren when
it detects the 1050 Hz weather alert tone, then opens the squelch and
remains on the weather channel.
SAME 1-5 - the scanner sounds a weather alert siren for the
programmed county, then opens the squelch and remains on the weather
channel.
All FIPS - the scanner sounds a weather alert siren for any programmed
county, then opens the squelch and remains on the weather channel.

Using Fire Tone-Out

With the tone out feature, the scanner monitors up to 10 different channels for paging
tones (two-tone sequential, single tone, and group tone). See also Hardware: Tone-
Out at WPA Scanner.
Tone-Out Standby Mode is used if you know and use programmed
tones.
Tone-Out Search Mode is used if you don't know the tones.

Setting up Tone-Out

1. Press MENU. Scroll to 'Tone-Out for...' and press E/yes.
2. Scroll to 'Tone-Out Setup' and press E/yes.
3. Scroll to 'Tone-Out 1' and press E/yes.
4. At 'Edit Name' press E/yes. See Entering Text.
Scroll to 'Set Frequency' press E/yes.
5.
6. At 'Edit Frequency' press E/yes. Enter the frequency to monitor for Tone-Out
and press
E/yes to save and exit.
7. Scroll to 'Set Modulation' and press E/yes.
8. Scroll to Auto, FM, or NFM and press E/yes to save and exit.
9. Scroll to 'Set Attenuator' and press E/yes.
10. Scroll to On or Off and press E/yes to save and exit.
11. Press Menu to return.
12. Scroll to 'Set Tone' and press E/yes.
110