2. Set the switch (SW301) of RS232C conversion
adapter to the "FLASH UCOM" side. (Fig. 1)
3. Connect the writing port of this unit to the serial
port (RS232C) of the PC with RS232C cross
cable, RS232C conversion adapter and flexible
flat cable as shown below. (Fig. 1)
PC
Serial port (RS232C) /
RS232C cross cable /
4. Start up "DSP_FLASHER_v3.0_M16C80.exe".
"DSP FLASHER_V3.0" is displayed. (Fig. 2)
5. Click [...]. (Fig. 2)
Select "U863xxxx.mot" (U model) / "VX63xxxx.mot"
(C, R, T, K, A, B, G, E, F, L models). (Fig. 2)
RX-V863/HTR-6180/DSP-AX863SE/DSP-AX863
Rear panel
RS232C conversion adapter /
Flexible flat cable (9P) /
SW301
FLASH
OTHER
UCOM
Fig. 1
J model
U model
C, R, T, K, A, B, G, E, F, L models
Fig. 2
Writing port /
27