Resetting The Use Time; Hdd Or Fan Error Indicator - Sanyo DSR-300P Service Manual

1. RESETTING THE USE TIME

1.Press the MENU button twice. Display the "MAIN MENU 2".
2.Use the [ ] button or the [
"7. POWER FAILURE/USED TIME" and then press the CUE
([ ]) button to display the "POWER FAILURE/USED TIME"
screen.
3.Press and hold the [STILL] button (or approximately 4 sec-
onds) until the cursor appears.
4.Use the [ ] button or the [
the item to be reset.
5.Press the [MENU RESET] button until the value for the se-
lected item is reset.
6.Press the EXIT/OSD button to finish.

2. HDD OR FAN ERROR INDICATOR

1.If a HDD or fan error occurs, the CHANGE DISK button and
indicator LED flashes.
2.Fan error is "HDD case fan" or "SET fan".
] button to move the cursor to
] button to move the cursor to
<POWER FAILURE>
F A I LURE
RECOVER
DISK1 USE
POWER
ERROR RESET
FIRMWARE : MAIN 1.13-10 / SUB 1.04-02
− 5 −
– – – – – – – : – –
– – – – – – – : – –
<USED TIME>
: 0 0 0 0 0 H
: 0 0 0 0 0 H
: 0 0 0 0
CHANGE DISK button and indicator