2-60 PERIODIC MAINTENANCE
Periodic Maintenance Procedures
Brake Fluid Change
The procedure to change the front brake fluid is as fol-
lows. Changing the rear brake fluid is the same as for
the front brake.
Level the brake fluid reservoir.
Remove the reservoir cap.
Remove the rubber cap from the bleed valve [A] on the
Attach a clear plastic hose [B] to the bleed valve, and run
the other end of the hose into a container.
Fill the reservoir with fresh specified brake fluid.
Change the brake fluid.
Repeat this operation until fresh brake fluid comes out
from the plastic hose or the color of the fluid changes.
1. Open the bleed valve [A].
2. Apply the brake and hold it [B].
3. Close the bleed valve [C].
4. Release the brake [D].
The fluid level must be checked often during the chang-
ing operation and replenished with fresh brake fluid. If
the fluid in the reservoir runs out any time during the
changing operation, the brakes will need to be bled
since air will have entered the brake line.
Front Brake: Repeat the above steps for the other
Torque - Front Master Cylinder Reservoir Cap Screws: 1.5
N·m (0.15 kgf·m, 13 in·lb)
Follow the procedure below to install the rear brake fluid
reservoir cap correctly.
First, tighten the rear brake fluid reservoir cap [B] clock-
wise [C] by hand until slight resistance is felt indicating
that the cap is seated on the reservoir body, then tighten
the cap an additional 1/6 turn [D] while holding the brake
fluid reservoir body [A].
Tighten the bleed valve, and install the rubber cap.
Torque - Bleed Valves: 7.8 N·m (0.80 kgf·m, 69 in·lb)
After changing the fluid, check the brake for good braking
power, no brake drag, and no fluid leakage.
If necessary, bleed the air from the lines.