Lincoln Electric RANGER 250 SVM150-A Service Manual page 115

F-65
ENGINE/STATOR/ROTOR REMOVAL AND REPLACEMENT (continued)
1. STATOR
2. BRUSH HOLDER ASSEMBLY
3. ROTOR THRU-BOLT
4. BLOWER FAN
5. TOLERANCE RING
6. ROTOR BEARING
7. IDLER SOLENOID
8. ROTOR
9. LIFTING EYE
2
5
3
Stator/Rotor Assembly Removal
Refer to Figure F.30.
1. Support the stator with the hoist.
2. Using the 1/2" wrench, remove the bolt,
washers, and nut holding the muffler to the
stator (Onan engine machines). Remove the
bolts and washers holding the muffler to the
engine and remove the muffler.
3. Disconnect the idler solenoid linkage at its
clip.
TROUBLESHOOTING & REPAIR
FIGURE F.30 – STATOR AND ROTOR REMOVAL
1
4
RANGER 250
8
6
7
4. Using the 7/16" wrench, remove the two nuts,
lock washers, and bolts holding the brush
holder assembly to the stator frame.
Remove the brush holder assembly.
5. Unscrew the fan to remove it from the shaft.
Turn the fan counterclockwise. Be careful not
to lose the washer that fits between the blow-
er fan and the rotor.
F-65
9