Chapter 11: System Board Jumper Settings - PIONEERPOS CYPRUS Core Pentium-Series User Manual

Chapter 11: System Board Jumper Settings

WARNING:
This section is written for TECHNICALLY QUALIFIED PERSONNEL ONLY. Modifying jumper setting to other than
manufacturer default setting may result in damages of device. Damages due to customer modification will VOID
factory warranty on motherboard and CYPRUS terminal. PioneerPOS will not be responsible for loss and
damages on Cyprus terminal and any other devices due to user modification. Call 909-468-9757 option 2 or email
support@pioneerpos.com
(Highlighted item indicates factory default setting)
J1: LCD voltage setting
Connector: HEADER 1X3P,S/T,2.0mm,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 5V
2-3 3V
J2: INVERTER voltage SEL
Connector: HEADER 1X3P,S/T,2.0mm,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 12V
2-3 5V
J3: INVERTER control SEL
Connector: HEADER 1X3P,S/T,2.0mm,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 DC control
2-3 PWM control
CLRTC
Connector: HEADER 1X3P G/F S/T 2.54MM CHARL
Jumper: MINI JUMPER 2P 2.54MM CLOSE C-S
1-2 Normal
2-3 Clear CMOS
KB2: KB/MS signal by pass to KB1
Connector: HEADER 2X3P S/T,2.54MM,DIP
Jumper: MINI JUMPER 2P,2.0MM,F,SMT
1-2 KB2
3-4 KB2
Manual for CYPRUS (V1.0) (Core Pentium & Core i-Series)
for help.
(default)
(default)
(default)
(default)
Pin 1
Pin 1
Pin 1
Pin 1
Pin 1
Page 31