Canon IB4000 series Online Manual page 341

Hide thumbs Also See for IB4000 series:
Table of Contents

Advertisement

Make sure that there is no source of radio wave interference in your vicinity.
Check7
If a device (e.g. microwave oven) using the same frequency bandwidth as the wireless station is placed
nearby, the device may cause interference. Place the wireless station as far away from the interference source
as possible.
Are you trying to connect 6 devices or more?
Check8
You can connect up to 5 devices using the access point mode.
Cannot Communicate with the Printer over the Wired LAN
Make sure that the printer is turned on.
Check1
Make sure that the LAN cable is connected properly.
Check2
Make sure that the printer is connected to the router with the LAN cable. If the LAN cable is loose, connect the
cable properly.
If the LAN cable is connected to the WAN side of the router, connect the cable to the LAN side of the router.
If the problem is not resolved, perform setup again according to the instructions on our website.
Cannot Print from a Computer Connected to the Network
Make sure that the network settings of the computer are correct.
Check1
For the procedures to set up the computer, refer to the instruction manual of your computer or contact its
manufacturer.
If the printer driver is not installed, install it.
Check2
Install the printer driver from our website.
When using wireless LAN, make sure that access control is not set to the
Check3
access point.
For the procedures to connect an access point and set it up, refer to the instruction manual of your access
point or contact its manufacturer.
Note
• To check the MAC address or the IP address of the computer, see
Address of the
Computer.
Checking the IP Address or the MAC
341

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents