MK-660 tile saw
DiaGONal CUttiNG
NOte: To cut 45º Diagonals, the 45º Flat Angle Guide (MK Diamond Part No. 134577-MK) should be
used.
DO NOt FORCe tHe tOOl. It will do the job better and safer at the rate for
CaUtiON
which it was designed.
(A)
Remove the adjustable Cut-
ting Guide
NOte:
If cutting the tile in two equal halves, align the tile in the V-notch of the movable Cutting Table Ruler/Stop.
(D)
Position the tile against the
Dual 45° Flat Angle Guide
and the Ruler/Stop
(G)
Perform the cut
(B)
Place the Dual 45° Flat Angle
Guide on the Ruler/Stop
(E)
Turn the motor ON
(H)
Turn the motor OFF when
work is complete
24
OPeRatiON
(C)
Position the Dual 45° Flat Angle
Guide and tighten the retaining
thumbscrew
(F)
Verify cooling flow on both sides
of the blade (See Maintenance
Section to adjust flow)