Setup For Operation; Portable Generator - MK Diamond Products MK-660 Owner's Manual & Operating Instructions

MK-660 tile saw
MK-660 saw setUP FOR OPeRatiON
1. Check for damaged, broken, or missing parts.
CaUtiON
2. Verify the On/Off switch is in the OFF position.
3. Before connecting the MK-660 Saw to a power supply, be sure the voltage, cycle
4. If using an extension power cord, make sure the length and wire gauge
5. Use an approved Ground Fault Circuit Interrupter (GFCI).
6. Do not cover the motor vents as this could lead to motor overheating.
NOte: In order to avoid breaker tripping, a 20-amp circuit breaker should be used.
NOte: MK Diamond has available, as an accessory item, (Part # 152610) a plug-in GFCI that
may be plugged into a properly installed and grounded 3-pole outlet.

PORtaBle GeNeRatOR

If using a portable generator to provide power, ensure the generator meets the following minimum
requirements: 8 KW 120/240 volts
and phase of the job site power source meet the requirements of the table below:
VOLTAGE:
CYCLE:
PHASE:
correspond to the requirements listed in the table on page 10. An extension
power cord that is too small in wire gauge (diameter), or too long in length, will
cause the motor to overheat and could cause premature failure.
(A) Ensure the ON/OFF Switch is in the OFF position
(B) Plug MK-660 Saw into the GFCI
(C) Plug the GFCI into the power source
120v
60hz
1-phase
66.7/33.3 amps Single Phase
22
OPeRatiON