HP Pro 3330 Microtower Maintenance & Service Manual page 110

CAUTION:
When the battery is removed or replaced, the CMOS settings will be cleared. Refer to the
Troubleshooting Without Diagnostics on page 141
settings.
NOTE: Batteries, battery packs, and accumulators should not be disposed of together with the
general household waste. In order to forward them to recycling or proper disposal, please use the
public collection system or return them to HP, its authorized partners, or its agents.
CAUTION:
equipment. Before beginning these procedures, ensure that you are discharged of static electricity by
briefly touching a grounded metal object.
1. Prepare the computer for disassembly
2. Remove the access panel
NOTE:
3. Locate the battery and battery holder on the system board.
4. To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
5. To insert the new battery, slide one edge of the replacement battery under the holder's lip with
the positive side up (2). Push the other edge down until the clamp snaps over the other edge of
the battery.
6. Replace the computer access panel.
7. Plug in the computer and turn on power to the computer.
8. Reset the date and time, your passwords, and any special system setups, using Computer
Setup. Refer to
100 Chapter 7 Removal and Replacement Procedures – Microtower (MT) Chassis
Before replacing the battery, it is important to back up the computer CMOS settings.
Static electricity can damage the electronic components of the computer or optional
(Access Panel on page
It may be necessary to remove an expansion card to gain access to the battery.
Computer Setup (F10) Utility on page
chapter for information on backing up the CMOS
(Preparation for Disassembly on page
49).
8.
48).