LG DF6810WW Service Manual page 36

Table of Contents

Advertisement

ERROR MESSAGE
EXCESS ERROR
displayed
Condition
Excessive water is sup-
plied than normal water
level.(Automatically drain
Pump operated.)
THERMAL ERROR
displayed
Condition
The resistance of ther-
mistor not normally out put.
MOTOR ERROR
displayed
Condition
The Motor is working
abnormally.
HEATER ERROR
displayed
Condition
The water is not heated or
the temperature in the Tub
is overheated to over 194ßF
POSSIBLE CAUSE
FOR ERROR OCCURRENCE
The Inlet Valve is troubled.
The Controller is troubled.
The Inlet Water Temperature is
very high. (over 194 )
Wiring connection is OK?
The Thermistor is OK?
Wiring connection is OK?
The Impeller of Washing Pump is
locked.
The rotor of Washing Motor is
locked.
The Blade is locked.
The Circuit of Heater is troubled.
The Thermistor is troubled.
The Heater is shorted.
The Relay Circuit is troubled.
- 37 -
- 37 -
REMEDY
Replace the Inlet Valve.
Repair or replace the Controller.
Check the temperature. (Test Mode)
If the temperature is displayed,
adjust the Inlet Water
Temperature to 120 .
If the temperature is not
displayed,
check the wiring connection.
check the electric resistance
of Thermistor.
(11~14k
at 77 )
Replace the PCB.
Check the wiring connection.
Replace the cause of restriction.
Replace the Washing Motor.
Replace the PCB.
Repair the Circuit of Heater.
Replace the Thermistor.
Replace the Heater.
Repair the Relay Circuit..

Advertisement

Table of Contents
loading

Table of Contents