HP EliteDesk 705 G1 Hardware Reference Manual page 44

9. Align the guide screws on the drive with the J-slots on the sides of the drive bay. Press the drive
up into the drive bay then slide it forward until it locks in place.
10. Connect the power cable (1) and data cable (2) to the back of the hard drive.
NOTE:
SATA connector labeled SATA0 on the system board. If it is a secondary drive, connect the data
cable to one of the light blue SATA connectors on the system board.
38 Chapter 2 Hardware upgrades
If the 2.5-inch hard drive is the primary drive, connect the data cable to the dark blue