Connecting The Console - Cisco SNS 3415 Installing Manual

Chapter 8 Installing the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances
Table 8-1
Type
10BASE-T
100BASE-TX
1000BASE-T
Figure 8-4
Figure 8-4
RJ-45 connector
Table 8-2
Table 8-2
Ethernet Port Pin
1
2
3
4
5
6
7
8

Connecting the Console

Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Your Cisco SNS-3415 or Cisco SNS-3495 appliance has a DCE-mode console port for connecting a
console terminal to your appliance. The appliance uses a DB-9 serial connector for the console port.
The console port on the Cisco SNS-3415 or Cisco SNS-3495 appliance includes an EIA/TIA-232
asynchronous serial (DB-9) connector. This serial console connector (port) allows you to access the
appliance locally by connecting a terminal—either a PC running terminal-emulation software or an
ASCII terminal—to the console port.
Ethernet Cabling Guidelines
shows the Ethernet RJ-45 port and plug.
RJ-45 Port and Plug
8 7 6 5 4 3 2 1
lists and describes the RJ-45 pin signals used on the connector.
Ethernet Port Pinout
Signal
TxD+
TxD–
RxD+
Termination network
Termination network
RxD–
Termination network
Termination network
Description
EIA Categories 3, 4, or 5 UTP (2 or 4 pair) up to 328 ft (100 m)
EIA Category 5 UTP (2 pair) up to 328 ft (100 m)
EIA Category 6 UTP (recommended), Category 5E UTP or
5 UTP (2 pair) up to 328 ft (100 m)
Description
Transmit data +
Transmit data –
Receive data +
No connection
No connection
Receive data –
No connection
No connection
Installation and Upgrade Guide for Cisco Secure Access Control System 5.6
Connecting Cables
8-9