Installing The Hydraulic Module; Installation Precautions; Positioning The Hydraulic Module - Fujitsu AOYA18LALL Installation And Operating Manual

Heat pump air/water split single service
Hide thumbs Also See for AOYA18LALL:
Table of Contents

Advertisement

Heat pump, Split, single service

Installing the hydraulic module

2.5

Installation precautions

2.5.1
The room in which the appliance operates must
comply with the prevailing regulations.
To facilitate maintenance and to allow access to the
various components, we recommend that you
provide sufficient space all around the hydraulic
module (figure 15).
Be careful not to bring inflammable gas near to the
heat pump during its installation, in particular when
it requires brazing
Figure 15 - Minimum installation clearances
around the hydraulic module and distances to the
combustible partitions
5
4
5
Installation and operating manual "1350-EN"
150 mm
200 mm
150 mm
1000 mm
Figure 17 - Removing the sides and fixing the support (S)
The appliances are not fireproof and should not
therefore be installed in a potentially explosive
atmosphere.

Positioning the hydraulic module

2.5.2
- 1, 2, 3 : Remove the front panel (2 screws A, figure 16)
- 4, 5 : Remove the sides (4 screws B, figure 17).
- Fix the support solidly (3 screws and plugs) to a flat,
hard-wearing wall (not a light partition) ensuring
that it is correctly levelled.
- Hook the appliance onto its support.
- Refit the sides.
- Refit the front facing.
3
Figure 16 - Removing the front facing
B
(S)
150 mm
240 mm
B
A
2
1
200 mm
505 mm
90 mm
305 mm
(S)
17

Hide quick links:

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

Table of Contents