Configuration Examples - Cisco ASR 9000 Series Configuration Manual

Configuration Examples

Last Five Events
--------------------------------------------------------------------
MINWARNCROSS: Noise crossed minor-warn threshold at Thu May 13 09:54:10 2010
MAJWARNCROSS: Noise crossed major-warn threshold at Thu May 13 09:54:11 2010
MAJWARNCLEAR: Noise cleared major-warn threshold at Thu May 13 10:27:25 2010
MINWARNCLEAR: Noise cleared minor-warn threshold at Thu May 13 10:28:14 2010
Clearing Link Noise Monitoring States and Statistics
You can use the clear controller lnm command to reset LNM states or clear statistics and reset them to
zero.
There should not normally be any need to clear the LNM controller states. The state option resets the
LNM configuration which causes an update of the current LNM states in the system. Therefore, under
normal conditions, if the controller is in alarm state, the reset should continue to report the alarm state;
alternatively, if the controller is clear of any alarms, the reset will show the stable state. The use of the
clear controller lnm state command does not actually clear any alarms, but causes a refresh of their
values in the system. Therefore, this command can be used if the reported controller state should happen
to be out of synchronization with the actual controller state.
To reset LNM states, use the clear controller lnm command as shown in the following example:
RP/0/RSP0/CPU0:Router# clear controller t1 0/1/0/0/1/1 lnm state
To clear LNM statistics and reset counters to zero, use the clear controller lnm command as shown in
the following example:
RP/0/RSP0/CPU0:Router# clear controller t1 0/1/0/0/1/1 lnm statistics
RP/0/RSP0/CPU0:Router# show controller T1 0/1/0/1/1/1 lnm statistics
Thu May 13 11:26:20.991 PDT
Controller T1 0/1/0/1/1/1
Monitoring type
---------------
Create
Update
Delete
Clear
Noise Crossed
Noise Cleared
Configuration Examples
This section contains the following examples:
•
•
•
•
•
Cisco ASR 9000 Aggregation Services Router Interface and Hardware Component Configuration Guide
484
Configuring Clear Channel T3/E3 and Channelized T3 and T1/E1 Controllers on the Cisco ASR 9000 Series Router
Configuring a Clear Channel T3 Controller: Example, page 485
Configuring a T3 Controller with Channelized T1 Controllers: Example, page 485
Configuring BERT on a T3 Controller: Example, page 486
Configuring Link Noise Monitoring on a T1 Controller: Examples, page 487
QoS on T3 Channels: Example, page 488
Minor-Warn Major-Warn
------------ ------------
0 0
0 0
0 0
0 0
0 0
0 0
OL-32684-01