Usb Device - Sony DAV-TZ100 Operating Instructions Manual

Symptom
The Control for HDMI function
does not work.
No sound is output from the
system and TV while using the
System Audio Control function.

USB device

Symptom
"OVERLOAD," "REMOVE
USB," then "PUSH POWER"
appear in the front panel display.
Are you using a supported USB
device?
There is no sound.
The sound is distorted.
There is noise or the sound skips. • Turn off the system, then reconnect the USB device.
88
GB
Remedy
• When "HDMI" does not light up in the front panel display, check the HDMI
connection (page 21).
• Set [CONTROL FOR HDMI] in [HDMI SETUP] to [ON] (page 52).
• Make sure that the connected component is compatible with the [CONTROL
FOR HDMI] function.
• Check that the AC power cord (mains lead) of the connected component is
connected securely.
• Check the connected component's setting for the Control for HDMI function.
Refer to the operating instructions supplied with the component.
• If you change the HDMI connection, connect and disconnect the AC power
cord (mains lead), or have a power failure, set [CONTROL FOR HDMI] in
[HDMI SETUP] to [OFF], then set [CONTROL FOR HDMI] in [HDMI
SETUP] to [ON] (page 52).
• For details, see "Using the Control for HDMI Function for "BRAVIA" Sync"
(page 59).
• Set [AUDIO (HDMI)] in [HDMI SETUP] to [ON] (page 52).
• Make sure that the connected TV is compatible with the System Audio Control
function.
• For details, see "Using the Control for HDMI Function for "BRAVIA" Sync"
(page 59).
Remedy
• A problem has been detected with the level of electrical current from the
(USB) port. Turn off the system and remove the USB device from the
(USB) port. Make sure there is no problem with the USB device. If this display
pattern persists, contact your nearest Sony dealer.
• If you connect an unsupported USB device, the following problems may occur.
See "Playable USB Devices" (supplement) for the supported device types.
– The USB device is not recognized.
– File or folder names are not displayed on this system.
– Playback is not possible.
– The sound skips.
– There is noise.
– A distorted sound is output.
– Transferring stops before it is finished.
• The USB device is not connected correctly. Turn off the system, then reconnect
the USB device.
• The bit rate used when encoding the audio files was low. Transfer audio files
encoded with higher bit rates onto the USB device.
• Noise may have entered during the transferring process. Delete the file, and try
transferring again.
• Copy the files to your computer, format the USB device in FAT12, FAT16, or
FAT32 format, and transfer the files to the USB device again.*
* This system supports FAT12, FAT16, and FAT32, but some USB devices
may not support all of these. For details, refer to the operating instructions of
each USB device or contact the manufacturer.